Hum tech electronics
Electronics repair made easy
About UsMission statementCRT Television troubleshooting guideCRT Television repair courseBasic electronics course DVD Player repair guideCRT TV Repair Case Histories Vol.1CRT TV repair case histories Vol.2my blogRecommended booksContact UsSite Mapnewsletterfree ebook download
‘No disc” symptoms on JVC DVD player solved
SONY TV DEAD repaired
Do it yourself series lamp current limiter
‘No disc” symptoms on JVC DVD player solved
What is the future of electronics repairing?
Understanding how flyback transiformer works
Understanding markings on capacitor body

How I solved ‘No disc” symptoms on JVC DVD player

No disc problems in all types of DVD is a common phenomenon, before a DVD start reading the disc, there are several test it does just like the booting of the computer (CPu) called start up process.

If by any chance any of the stage is not working the DVD will display an error on the screen, most of the time it is disc error, no disc etc.

Among the components which are most suspected is the LENS, but from my experience this is one of the most stable components with a relatively very low failure rate.

Top suspect is the Spindle motor (the motor that spins the disc); over 75% no disc error is caused by this small motor where the disc sits on.



How to measure spindle motor with a DMM, set your meter to low resistance test (200 ohm) range, if it is okay should read between 5 and 20 ohms.

On analogue meter, this is my favorite set the meter to X1 and measure across the two wires coming from the motor(red and black) if the motor is okay, it will spins at very high speed indicating to you that it is up to the task.

A word of advice- I have found several of these motors which are not working right from the shop and therefore I advise you to ask the store keeper to give you the meter and test on the counter before taking it home only to realize that it’s not working. This is also true with other components make it a routine to test components before replacing them in circuit.

Back to my JVC DVD

As usual my first suspect- Spindle motor. Measuring this motor, YES it was dead short.

I replaced with a new one, alas still no change...Still no disc symptoms.

Looking at the logic circuit (motherboard) I noticed a swollen cap on +5 volt line. A good hint what might be pulling the spindle motor power supply down!